FPSINPUT.MHS_BAY_TO_BAY_MATRIX

FACILITY

VARCHAR2(6)

N

Facility is included in almost every join in the DWH so this represents a definitive split. A route must have all steps on tools in the same facility. A tool must process all lots in the same facility. If your site has multiple buildings where lots run on routes using tools in multiple buildings then everything should be one facility. For example, multiple Fab buildings. But if your site has independent facilities like Fab and Test and Assembly where lot may progress from one to the next but on different routes then these should be different facilities. Since this column is in virtually every table it is critical that the value here is exactly matches what is in the MES if the MES has facility. Use facility_display for the display friendly name displayed in applications. See site_name comment for client/site/facility example. (* from FPSINPUT.GEN_FACILITIES)

FROM_BAY

VARCHAR2(12)

N

Bay to move from.

TO_BAY

VARCHAR2(12)

N

Bay to move to.

BAY_TO_BAY_TRANSPORT_MODE

VARCHAR2(10)

Bay to bay transport mode. If no other mode is specified, this will be the value used to direct wip from bay to bay.

CAST_EXPEDITE_TRANSIT_SEC

NUMBER(5)

Estimated expedite transit time to move a cassette between bays. Primarily used by the Scheduler to estimate shorter transit times for expedite lots to allow for earlier scheduling.

CAST_IDEAL_TRANSIT_SEC

NUMBER(5)

Ideal transit time to move a cassette between bays used in cycle time X-factor calculations.

CAST_TRANSIT_SEC

NUMBER(5)

Estimated transit time to move a cassette between bays. Primarily used by the Scheduler and NextMove to estimate lot transit times.

INTERMEDIATE_STATION

VARCHAR2(32)

For NextMove, all moves from the from_bay to the to_bay should go to this station next.